CM2P201 User Guide
To output the service on the Modulation Output, you can simply put a tick in the box beside the
service you want to output. You can output multiple Service from different Source channels or
bypass the TS to Modulation output.
To Output the TS by Bypass mode, you can simply check the Bypass box of the TS. You can only
bypass 1 TS and cannot output other services from different channel sources. Bypass mode allows
you to keep the input signal automatically be redirected to Modulation output without re-scanning the
input or transferring it to output.
Multiplexing-Service Configuration> After output the services from IP input to Modulation output,
you can now edit the Service ID and other PID on the output. Click on the Service Configuration to
see this page, it shows the output service on this channel only.
To Next Page
Loading...
