CM2P201 User Guide
1. Bypass mode. In this mode, you can route a whole input transport stream towards an IP or
RF output which will be occupied only by this stream. Any attempt of routing other
stream/service towards this channel will be an error. This mode can only be set by clicking
the icon on the TS.
2. Multiplex mode is the counter part of the bypass mode. This mode allows the administrator
to perform the following operations:
a. Route a single service towards an output channel to create SPTS.
b. Route services towards a single output channel to create MPTS.
c. Route service/s AND stream/s from multiple channels towards a single output channel to
create MPTS.
In Descrambling Settings there are CAM1, CAM2, No Descrambling to choose. Click Apply or
Clear Config button on the right side to make the change take effect or clear all configurations.
CR2-DVBC-00 >System
On System page you can choose the modulation type as DVBC or DTMB Mode. Besides you can
also perform Import/Export License, Reboot the module, Restore the unit to factory defaults
and Log Export&Clear.
To Next Page
Loading...
