CM2P201 User Guide
Click +Descriptor then LCN Descriptor to check all the programs which are contained in this
frequency. Then set programs LCN.
Click +Descriptor and add the Cable Descriptor in. Then fill in the correct frequency and
symbol rate and choose the correct constellation of the TS (frequency). Then click OK. (this
operation should be set on Modulator module only).
Do same operations to add next TS (frequency) until NIT streams of all the frequencies have
been included. At last click Apply button to let all configuration take effect. Then searching
programs in your STB, you will get all programs in order of LCN which you set.
To Next Page
Loading...
