SPECIFIC RULES YOUR BAND SAW
WARNING: Do not let comfort or familiarity with the product replace strict adherence to product safety
rules. Failure to follow the safety instructions may result in serious personal injury.
1. WORK ENVIRONMENT. Do not operate the tool in wet or damp conditions; doing so significantly increases
the risk of electrical shock. Do not operate the tool in the presence of flammable liquids or gases; sparks generated
by the grinder could ignite these flammable materials.
2. PREVENTING ELECTRIC SHOCK. Hold power tool by insulated gripping surfaces, when performing an
operation where the cutting accessory may contact hidden wiring or its own cord. Cutting accessories contacting a
“live” wire may make exposed metal parts of the power tool “live” and could give the operator an electric shock.
3. PERSONAL SAFETY. Tie back long hair. Do not wear loose clothing or jewelry as they might get drawn in by
the tool. Always wear ANSI Z87.1-approved glasses with side shields, hearing protection and a dust mask when us-
ing the tool.
4. DUST PROTECTION. Wear a dust mask and work with a dust extraction device. Dust from material such as
paint containing lead, some wood species, minerals and metal may be harmful (contact with or inhalation of the dust
may cause allergic reactions and/or respiratory diseases to the operator or bystanders); certain kinds of dust are clas-
sified as carcinogenic (such as oak and beech dust) especially in conjunction with additives for wood conditioning.
5. SAW BLADE SAFETY. Use the correct size and style of blade. Inspect blades for cracks and missing teeth be-
fore each use. Do not operate with dull, cracked or badly worn blade. When replacing blades, make sure the blade
teeth are pointing down and towards the table. Check that the blade is properly tensioned (blade tensioning handle
tightened down) before operating.
6. WORKPIECE SAFETY. Workpieces should be securely fastened down so they don’t twist, rock, or slip while
being cut. Small pieces should be secured with clamps or fixtures. Do not hold small pieces with your hand. Work
slowly and carefully when cutting corners, sharp edges, ragged welds, and etc. to avoid snagging.
7. STARTING THE TOOL. Hold the tool firmly with both hands to resist starting torque. Turn on the tool and
let the blade come to full speed before contacting the workpiece.
8. DURING OPERATION. To prevent personal injury, maintain a firm grip on the tool with both hands and
keep the tool away from your body. Keep hands, hair and other beloved body parts away from the blade. Do not
run the tool while carrying it at your side. Never leave the band saw unattended while it is running.
9. PREVENT BURNING. Cutting material and the motor housing can get very hot during operation. Do not touch
the workpiece, saw blade or motor housing immediately after operation.
10. TURNING OFF THE TOOL. Lift the tool from the workpiece before turning the machine off. Do not put the
band saw down until the blade comes to a complete stop. Moving parts can grab the surface and pull the tool out of
your control. Turn off the tool, and unplug it from its electrical outlet before leaving
11. MAINTAINING AND MAKING ADJUSTMENTS. Always turn OFF and unplug the tool before cleaning,
making adjustments or changing attachments. Accidental start-ups may occur if the tool is plugged in during an ac-
cessory change or adjustment.
6
To Next Page
Loading...
Need help?
General
