Need help?Do you have a question about the Westermo TR-36 and is the answer not in the manual?
General| Type | Industrial Cellular Router |
|---|---|
| Cellular Technology | 4G LTE, 3G, 2G |
| Power Supply | 9-36 VDC |
| Operating Temperature | -40 to +70°C (-40 to +158°F) |
| Weight | 0.3 kg |
| Protocols | UDP, ICMP, SNMP, HTTP, HTTPS |
| Certifications | CE, FCC |
Safety requirements before installing the modem, including restricted access and qualified personnel.
Guidelines for handling, cleaning, and storing the unit to prevent damage and ensure proper operation.
Information on maintenance requirements, noting no specific maintenance is needed if used as intended.
Details test levels for various electromagnetic phenomena like ESD, RF fields, and transients.
Specifies operating temperature, humidity, altitude, and service life requirements.
Details specifications for power input and the Public Switched Telephone Network (PSTN) interface.
Covers specifications for Leased Line (LL) and RS-422/485 communication protocols.
Details electrical specifications, data rate, protocol, and connection for the RS-232 interface.
Diagrams and details for power input and PSTN connection terminals.
Illustrates connections for Leased Line and RS-422/485 interfaces.
Details the pinout and connections for the RS-232 DCE interface.
Configuration options for DTE speed and data format using S1 DIP-switch.
Settings for Leased Line mode and DTE interface selection using S2 DIP-switch.
Configuration for RS-422/485, Leased Line, PSTN backup, and remote configuration via S2 DIP-switch.
Settings for line speed, modulation, PLC parameters, flow control, and dial abort using S3 DIP-switch.
Configuration for modem defaults, DCD/DTR/DSR control, data compression, auto-retrain, and line mode via S4 DIP-switch.
Settings for RS-422/485 termination using S5 DIP-switch.
DTE speed and format settings for V.23 leased line operation using S1 DIP-switch.
Leased line mode and 2/4-wire selection for V.23 using S2 DIP-switch.
Termination settings for V.23 leased lines using S4 DIP-switch.
Safety precautions and grounding requirements before handling the unit.
Instructions for horizontally mounting the unit and ensuring proper airflow.
Steps for safely disconnecting and removing the unit.
Overview of the PC application for easy configuration of TR-36 features.
Reference to AT Commands Interface Guide for detailed command descriptions.
Procedure for configuring the TR-36 remotely via PSTN or other modems.
Example setup for connecting two TR-36 units using DTR signal for call initiation.
Step-by-step guide for establishing a connection between TDW-33 and TR-36.
Setup for TR-36 to answer calls silently based on Caller ID.
Dip switch settings for configuring leased line calling, answering, and wire selection.
Table showing cable specifications, resistance, attenuation, and maximum distances.
Settings for TR-36 485 in 2-wire half duplex mode at 38.4 kbit/s.
To Next Page
