Western CP600 - Operation, Safety & Maintenance

3
CP600 Pivot Operation Manual
POM-EN-December 2018
Section 1
Operation, Safety & Maintenance
Safety Symbols, Pictures and Denitions ................................. 3
Final Checks and Initial Operation ....................................... 5
Machine Alignment .................................................. 6
Cam and Safety Switch ............................................... 9
Maintenance Check List .............................................. 10
Power Drivetrain Maintenance ......................................... 12
Lockout/Tagout Procedures ............................................ 19
Tire Care .......................................................... 23
Winterizing ......................................................... 24
Lube & Oil Charts ................................................... 25
Service Log ........................................................ 27
Troubleshooting ..................................................... 30
Section 2
General Information
Span Tower Weights and Dimensions .................................... 2
Revolution Times and Water Application ................................. 4
Revolution Times and Water Application Charts ........................... 6
Sprinklers ......................................................... 7
End Guns- Nelson ................................................... 36
Standard Galvanized Drop Details ...................................... 37
Standard Flexible Hose Drop Detail ..................................... 38
Variable Spacing Drop Details .......................................... 39
Slurry Drops ........................................................ 40
Standard Galvanized Extended Drop Detail ............................... 41
Adjustable Drop ..................................................... 42
Section 3
Getting Started
Before Your Machine Arrives ........................................... 2
Slope Considerations ................................................ 3
Power Supply ...................................................... 6
Ground Rod Placement ............................................... 8
Pivot Pad (Concrete) ................................................. 10
Standard Pivot Pad (Concrete) ......................................... 11
6-5/8 Pivot Pad (Concrete) ............................................ 12
High Prole Pivot Pad (Concrete) ....................................... 13
Towable Pivot Pad (Concrete) .......................................... 14
Minimum Equipment for Machine Assembly/Set-up ......................... 15
Page iiiContents