Western CP600 - Pivot Pad (Concrete)

CP600 Pivot Operation Manual
POM-EN-December 2018
92
The pivot point is the center of the irrigation radius. Its location denes the area to be watered, so place-
ment of the pivot point is a critical part of the planning stage. It is vitally important that the pivot point be
located to maximize irrigation coverage while avoiding any potential obstacles. A survey of your property
completed by a professional surveyor would be most helpful in positioning your pivot.
The center of the eld should serve as only a tentative position for your pivot. Once you have determined
the exact center of your eld, the next step will be to review the eld once more and evaluate potential
hazards. You can then either clear the hazards or adjust the pivot point so that the spans maneuver around
them. If you decide to adjust the pivot point off-center, ensure that the new pivot will not cross the path of
any other pivots already operating in adjoining elds or other obstacles in the eld.
Your pivot will be delivered on a atbed truck. To make unloading easier, take the time to measure in a
straight line out from the pivot point and place a marker where each of the towers will go. This will guide
you in accurately off loading components.
The concrete pivot pad is the rst item of construction. If possible, the concrete work should be done prior
to delivery of the machine. Enough time should be allotted to ensure proper curing of the concrete pad.
Section 3-10
Getting Started
Pivot Pad (Concrete)