Western CP600 - Minimum Equipment for Machine Assembly;Set-up

CP600 Pivot Operation Manual
POM-EN-December 2018
97
1- Boom truck capable of lifting a minimum of 6,000 lbs., to a height of 15 feet (20 feet for high prole).
1- Nylon strap with same or better rating as boom truck, in good condition (not frayed or cut).
See CAUTION listed below.
1- Impact wrench, air or electric.
1- Each 9/16” through 1-1/4” impact sockets (deep well recommended).
2- Combination wrench set 7/16” through 1-1/2”.
1- Deep well socket set, 3/8” drive, 7/16” through 3/4”.
1- Deep well socket set, 1/2” drive, 9/16” through 1”.
1- Each 3/8” and 1/2” drive ratchet.
2- Alignment bars.
1- 18” pipe wrench.
2- 12” Channel lock pliers.
1- Large pry bar (approximately 6’)
1- Regular at screwdriver.
Note: Since Western Corporation recommends all wiring be completed by a professional
electrician, tools involving the electrical hook-up are not included.
CAUTION: Lifting with chain or cable can cause damage to coated surfaces.
97
97
97
Section 3-15
Getting Started
Minimum Equipment for Machine Assembly/Set-up