(17). SNAP-ROLL
This function allows you to execute snap rolls by flipping a
switch, providing the same input every time. It also removes
the need to change dual rates on the 3 channels prior to
performing a snap, as snap-roll always takes the servos to the
same position, regardless of dual rates, inputs held during
the snap, etc.
Setting Method:
Use up/down button to select SNAP-ROLL, OK button is to
enter editing.
Steps:
1. Use direction buttons to select editing part.
2. Use +/- button to set value. Press OK button for seconds can
back default.
3. Press EXIT after setting.
WFT09
INSTRUCTION
94
AIRPLANE
To Next Page
Loading...
