(6). DELAY
This function is to delay the aerobatics or throttle cut when
the helicopter is in the air so that to avoid the big trim change.
The Delay function provides a smooth transition between the
trim positions whenever OFFSET, REVO. MIXING, or
THROTTLE HOLD functions are turned on and off.
Setting Method:
Use up/down button to select DELAY, OK button is to enter
editing.
Steps:
1. Use direction buttons to select editing part.
2. Use +/- button to active or inhibit this function. Press OK
button for seconds can back default.
3. Press EXIT after setting.
WFT09
INSTRUCTION
49
HELICOPTER
To Next Page
Loading...
