10. REVOLUTION MIXING
This curve mix adds opposite rudder input to counteract the
changes in torque when the speed and collective pitch of the
blades is changed.
Setting Method:
Use up/down button to select Revolution mixing, OK button is
to enter editing.
Steps:
1. Flight(NORM IDLE1 IDLE2 IDLE3)
Use direction buttons to select editing part. Use +/- button to
select one curve.
2. Set Dual rate
Use direction button to select “D/R” and edit (one or two values
can be set separately or together). Press +/- button for seconds
can increase or delete the value. Press OKbutton for seconds
is to back default(60%).
3. Curve point setting(Normal/Advanced)
The below pane shows the points curve.
Select “Curve setting” in “SYS setting”, choose the curve.
For detail curve setting method please refer to Page 25.
4. Press EXIT after setting.
WFT09
INSTRUCTION
35
HELICOPTER
To Next Page
Loading...
