WFT09
INSTRUCTION
Setting Method:
Use up/down button to select PITCH CURVE SETTING, OK button
is to enter editing.
Steps:
1. Flight(NORM IDLE1 IDLE2 IDLE3)
Use direction buttons to select editing part. Use +/- button to
select one curve.
2. Set Dual rate
Use direction button to select “D/R” and edit (one or two values
can be set separately
or together). Press +/- button for seconds can increase or delete
the value. Press OK button for seconds is to back default(60%).
3. Curve point setting(Normal/Advanced)
The below pane shows the points curve.
Select “Curve setting” in “SYS setting”, choose the curve.
For detail curve setting method please refer to Page 25.
4. Press EXIT after setting.
34
HELICOPTER
To Next Page
Loading...
