(4). HI/LO PIT SETTING
This function is to set the high and low pitch position at di-
fferent flying modes.
This function can set knob VA/VB/VC/VR/VL to control or
controlled by user ”CTRL MAN”.
IF “CTRL MAN”, the pitch is set by “Rate”, the range is
between 60%-100%.
Setting Method:
Use up/down button to select HI/LO PIT setting, OK button
is to enter editing.
Steps:
1. Use direction buttons to select editing part.
2. Use +/- button to select “MODEL”.
Use +/- button to active or inhibit this function.
3. Use +/- button to set the “Pos”, low or high.
4. Use +/- button to set “Rate”. Press OK button for seconds
can back default.
5. Use +/- button to set control switch.
6. Press EXIT after setting.
WFT09
INSTRUCTION
47
HELICOPTER
To Next Page
Loading...
