11. TRIM STEP SETTING
This function is to change the rate at which the trim moves
when the TRIM LEVER is activated. The range is from 0 to
250. Generally larger trim steps are for models with larger
control throws or for first flights to ensure sufficient trim to
properly correct the model. Smaller trim steps are later used
to allow very fine adjustments in flight.
Setting Method:
Use up/down button to select Trim step setting, OK button
is to enter editing.
Steps:
1. Use direction buttons to select editing part.
2. Use +/- button to adjust the size of the step,
3. Repeat as desired for other channels.
3. Press EXIT after setting.
WFT09
INSTRUCTION
36
HELICOPTER
To Next Page
Loading...
