7. AUXILIARY CHANNELS SETTING
This function is for channel 5 to channel 9 function setting.
Setting Method:
Use up or down button to select Swash param setting, OK button
is to enter editing.
Steps:
1. Use direction buttons to select editing part.
2. Use +/- button to set the switches or knobs. The switches can
be set from A to F, the knobs can be set as VA, VB, VC, VL,
VR or none(-).
3. Use left or right direction button to set normal or reverse
direction of every channel.
4. Press EXIT after setting.
Channel
Switch
Direction
WFT09
INSTRUCTION
30
HELICOPTER
To Next Page
Loading...
