(17)-(20). PROG. CUR. MIX1-4
There are 4 curve mix program, the curve is made up by
2 to 11 point.
Setting Method:
Use up/down button to select PROG. CUR. MIX, OK button
is to enter editing.
Steps:
1. Use direction buttons to select editing part. Set any two
channels mix.
2. Use +/- button to active or inhibit “Mix”.
3. Use +/- button to active or inhibit “Link” and “TRIM”.
4. Use +/- button to active or inhibit “CTRL“.
5. Use +/- button to set the control switch position.
6. Set the curve point.(Normal/Advanced). Please refer to
page 25.
7. Press EXIT after setting.
WFT09
INSTRUCTION
53
HELICOPTER
To Next Page
Loading...
