PAGE 9
Installing Filled Bobbin and Threading The Bobbin Case
Hold the bobbin case with the slot in its edge up (left).
Hold the bobbin with fingers of the other hand so that the
end of the thread points in a CLOCKWISE direction. Insert
the bobbin into the case and pull
the thread into the case edge
slot (RIGHT). Then continue
pulling the thread under the
tension spring and into the fork-
shaped opening of the spring
(RIGHT), until about three
inches of thread protrudes.
Put Bobbin Case Back In Machine By Reversing Procedure Page 8
— The Last Step Before Sewing
Hold the end of the thread through the needle loosely in
the left hand and turn the machine wheel COUNTER -
CLOCKWISE until the needle goes down and comes back
up. The needle thread you hold will be looped by the
bobbin thread from below. Pull the looped thread out
straight and place BOTH threads under the presser foot
slot. Continue pulling the threads toward the back of the
machine for three to four inches.
Finish Every Sewing
Step The Right Way—
At the end of each
sewing operation turn
the machine wheel COUNTER-CLOCKWISE by
hand until the Take-Up Lever and the Needle are at
the highest position. Raise the Presser Foot and
draw some fabric toward the back and slightly to the
left, keeping the threads UNDER the presser foot.
Clip the threads with sharp scissors or by raising
them over top of the Machine Thread Cutter just
above the presser foot. Then pull down to cut the
threads using both hands to avoid bending the
needle. Leave the ends of both cut threads under
the presser foot.
To Next Page
Loading...
