PAGE 17
Many More Time-Saving Wonder Working
Available From Your Dealer At Modest Prices — Here Are Some
Order them by genuine part numbers shown
Ruffler-Pleater No. 1403
Just on one set of curtains for the house, you
will save hours and hours of time and nerve-
wracking tediousness by using your machine
and a Huffier. For pleating skirts and slip
covers; marking gift aprons, children's clothes
with ruffled finishing touches; adding fullness to
dress bodices, are just a few of the many uses
for this versatile attachment. Also while ruffling
a trimming you can sew it on the main fabric
simultaneously. Despite its wide range of
practical applications it is amazingly simple to
use.
Zipper Sew-in and Cording Foot No. 1873
Needed to sew in zippers by machine. Permits
stitching very close to the metal fastener for
smooth, secure results in a jiffy. Adjustable for
stitching on either side of foot — left or right.
Also needed for Cording.
Darning Spring No. 4990
Of great assistance when Darning or Mono-
gramming with Presser Foot removed from
machine—especially when using a hoop. It just
slips over the needle and hooks onto needle
clamp.
Edgestitcher No. 76554
The fast, foolproof and fine-finish way to sew
pipings, edgings and lace insertions. Easy to use
— with a range of slots to guide the fabrics and
the operator.
Binding Applier No. 74 1 59
Another tremendous time-saver. This attachment
folds plain, flat bias binding from a roll; also
hand-cut bias binding, AND applies it to edge of
material at the same time. Also does a fine job of
applying standard sizes of folded and two-tone
(two different colors) bindings simultaneously.
Almost a must for making children's garments
fast and easily.
Hemmers for Four Popular Hem Widths
To go with the Narrow Hemmer which came with
your machine. Order by number according to the
width of hems wanted: ¼ inch-No. 76550; ⅜
inch-No. 76551; ⅝ inch-No. 76552; ⅞ inch-No.
76553.
Attachment Holder No. 82528
NECESSARY FOR ATTACHMENTS ABOVE
To use the Edgestitcner, Binding Applier, or wider
Hemmers on your machine you must first install
the Attachment Holder in place of any Presser
Foot.
To Next Page
Loading...
