EN
WIKA operating instructions pressure gauge, model 2 per ATEX 21
14375375.01 12/2019 EN/DE
5. Transport, packaging and storage
5. Transport, packaging and storage
5.1 Transport
Check the instrument for any damage that may have been caused by
transport.
Obvious damage must be reported immediately.
CAUTION!
Damage through improper transport
With improper transport, a high level of damage to property
can occur.
▶
When unloading packed goods upon delivery as well as
during internal transport, proceed carefully and observe
the symbols on the packaging.
▶
With internal transport, observe the instructions in chapter
4.2 “Packaging and storage”.
Shocks can cause small bubbles to form in the ll uid of
lled instruments. This has no eect on the function of the
instrument.
5.2 Packaging and storage
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during trans-
port (e.g. change in installation site, sending for repair).
Permissible storage temperature
Model 2, PG23CP: -40 ... +70 °C
Model PG23LT: -70 ... +70 °C
To Next Page
Loading...
Need help?
General
