EN
WIKA operating instructions pressure gauge, model 2 per ATEX 23
14375375.01 12/2019 EN/DE
6. Commissioning, operation
For parallel threads, use at gaskets, lens-type sealing rings or WIKA
prole sealings at the sealing face
. With tapered threads (e.g. NPT
threads), sealing is made in the threads
, using a suitable sealing
material (EN 837-2).
The torque depends on the sealing used. In order to orientate the
measuring instrument so that it can be read as well as possible, a
connection with LH-RH union or union nut should be used.
When a blow-out device is tted to a pressure gauge, it must be protect-
ed against being blocked by debris and dirt.
6.2 Requirementsfortheinstallationpoint
If the line to the measuring instrument is not adequately stable, an instru-
ment bracket should be used for fastening (and possibly via a exible
capillary). If vibrations cannot be avoided by means of suitable instal-
lation, instruments with liquid lling should be used. The instruments
should be protected against coarse dirt and wide uctuations in ambient
temperature.
Spanner ats
Sealing in the thread
Sealing face
To Next Page
Loading...
Need help?
General
