Williams Rhapsody - Appendix A: Default Settings

27
APPENDIX A
Default Settings
The table below shows the piano factory default settings and whether or not user changes to these settings are
retained after a power-cycle (turning the device off and on).
At power-on, the following MIDI data will be sent to the sound engine, the USB MIDI and the MIDI Out:
1. Bank Change MSB=0, LSB=0, PGM=0 - set sound engine to piano voice
2. Reverb default value
Parameter Factory Default Retained on Power-Down
ProgramNumber&VoiceSelected 000 - Grand Piano No
Bank MSB Number 000 No
Bank LSB Number 000 No
Main MIDI Transmit Channel Channel 1 No
Octave shift 0 No
Transpose 0 No
Local On No
[DATA CONTROL] Assignment Data = Tempo Yes
Reverb On/Off Reverb On Yes - store for each sound
Reverb Depth Defaults for each sound Yes - store for each sound
Chorus On/Off Chorus Off Yes - store for each sound
Chorus Depth Defaults for each sound Yes - store for each sound
VelocityCurveSelected NORMAL Yes
Split Point B2 Yes
VoiceVolume 127 No
LayerVolume 100 Ye s
SplitVolume 127 Yes
MetronomeVolume 127 Ye s
Master Tune 0 Yes
Tem p o 120 Ye s
LayerModeVoice String Yes
SplitModeVoice 8-UprightBass Yes
Layer Mode On/Off Off No
Split Mode On/Off Off No