en-US Safety
6 WILO SE 2017-03
Signal words
▪DANGER!
Violation causes death or serious injury!
▪WARNING!
Violation can cause (serious) injury!
▪CAUTION!
Violation can cause material damage, total breakdown
is possible.
▪NOTICE!
Useful indication for handling the product
Symbols
The following symbols are used in these instructions:
Danger of electrical voltage
Danger from bacterial infection
Danger of explosion
General warning symbol
Warning of crushing
Warning of cutting injuries
Warning of hot surfaces
Warning of high pressure
Warning of suspended load
Personal protective equipment: Wear a protective
helmet
Personal protective equipment: Wear foot protec-
tion
Personal protective equipment: Wear hand protec-
tion
Personal protective equipment: Wear mouth protec-
tion
Personal protective equipment: Wear safety goggles
Working alone forbidden! A second person must be
present.
Useful indication
Text designations
‡ Prerequisite
1. Work step/list
⇒ Indication/instruction
▶ Result
2.2 Personnel qualifications
The personnel must:
▪Be informed of the locally applicable accident preven-
tion regulations.
▪Have read and understood the 'Installation and operat-
ing instructions'.
The personnel must have the following qualifications:
▪Electrical work: A qualified electrician (in accordance
with EN50110-1) must carry out the electrical work.
▪Installation-/dismantling work: The technician must be
trained to handle the necessary tools and required fas-
tening materials for the present building site.
▪Maintenance work: The technician must be familiar
with the use of operating fluids and their disposal. Fur-
thermore, the technician must have basic knowledge of
engineering.
Definition “Qualified Electrician”
A qualified electrician is someone with suitable techni-
cal training, knowledge and experience, who can rec-
ognize and avoid the dangers of electricity.
2.3 Electrical work
▪A qualified electrician must carry out the electrical
work.
▪When connecting to the power supply, adhere to the
local regulations as well as the provisions of the local
energy supply company.
▪Before all work, disconnect the product from the power
supply and secure against unauthorized switch-on.
▪The personnel are instructed in how to implement the
electrical connection as well as the shutdown methods
of the product.
▪Adhere to the technical information in these 'Installa-
tion and operating instructions' as well as on the rating
plate.
▪Earth product.
▪Observe the manufacturer’s regulations when connect-
ing to electrical switchgears.
▪Adhere to the regulations for electromagnetic compat-
ibility when connecting to electronic start controls (e.g.
soft start or frequency converter). If required, consider
special measures (e.g. shielded cables, filters etc.).
▪Immediately replace defective power supply cables.
Contact customer service.
To Next Page
Loading...
Need help?
General
