en General information
4 WILO SE 2021-12
1 General information
1.1 About these instructions
These instructions form part of the product. Compliance with the instructions is essen-
tial for correct handling and use:
ƒ Read the instructions carefully before all activities.
ƒ Keep the instructions in an accessible place at all times.
ƒ Observe all product specifications.
ƒ Observe the markings on the product.
The language of the original operating instructions is German. All other languages of
these instructions are translations of the original operating instructions.
1.2 Copyright
WILO SE © 2022
The reproduction, distribution and utilization of this document as well as the commu-
nication of its contents to others without express authorization is prohibited. Offenders
will be held liable for the payment of damages. All rights reserved.
1.3 Subject to change
Wilo shall reserve the right to change the listed data without notice and shall not be li-
able for technical inaccuracies and/or omissions. The illustrations used may differ from
the original and are intended as an example representation of the device.
2 Safety
This chapter contains basic instructions for the individual life cycles of the product.
Failure to observe this information carries the following risks:
ƒ Danger to persons from electrical, mechanical and bacteriological effects as well as
electromagnetic fields
ƒ Environmental damage from discharge of hazardous substances
ƒ Damage to property
ƒ Failure of important product functions
ƒ Failure of required maintenance and repair procedures
Failure to observe the instructions will result in the loss of any claims for damages.
The directions and safety instructions in the other sections must also be observed!
2.1 Identification of safety instruc-
tions
These installation and operating instructions set out safety instructions for preventing
personal injury and damage to property, which are displayed in different ways:
ƒ Safety instructions relating to personal injury start with a signal word and are pre-
ceded by a corresponding symbol.
ƒ Safety instructions relating to property damage start with a signal word and are
displayed without a symbol.
Signal words
ƒ DANGER!
Failure to follow the instructions will result in serious injury or death!
ƒ WARNING!
Failure to follow instructions can lead to (serious) injury!
ƒ CAUTION!
Failure to follow instructions can lead to property damage and possible total loss.
ƒ NOTICE!
Useful information on handling the product
Symbols
These instructions use the following symbols:
General danger symbol
Danger of electric voltage
Warning of hot surfaces
Warning of magnetic fields
Notices
To Next Page
Loading...
Need help?
General
