English
88 WILO SE 05/2015
4.2.3.0 Countdown, pump
cycling
Time to pump cycling in h (at a
resolution of 0.1 h)
Shown only for double pump
master and internal pump
cycling Can be set in the
service menu <5.1.3.0>
4.2.4.0
Remaining time
until pump kick
Time until the next pump kick
(after the pump has had a 24 h
standstill (e.g. via External off), it
will be automatically operated
for 5 seconds)
Only displayed if pump kick is
activated
4.2.5.0
Mains On counter Number of switching-on proce-
dures of the supply voltage
(each occasion the supply volt-
age is established after an inter-
ruption is counted)
4.2.6.0 Pump kick counter Number of pump kicks carried
out
Only displayed if pump kick is
activated
4.3.0.0
States
4.3.1.0 Base-load pump The value display statically
shows the identity of the regular
base-load pump.
The unit display statically shows
the identity of the temporary
regular base-load pump.
Only displayed for double
pump master
4.3.2.0 SSM ON
State of the SSM relay if there is
no fault signal
OFF
State of the SSM relay if no fault
signal is present
4.3.3.0 SBM ON
State of the SBM relay if a readi-
ness/operation or mains On sig-
nal is present
OFF
State of the SBM relay if no read-
iness/operation or mains On sig-
nal is present
SBM
Run signal
No. Designation Type Symbol Values/explanations Display conditions
To Next Page
Loading...
Need help?
General
