Wilo VeroTwin-DP-E Series User Manual

English
Installation and operating instructions Wilo-VeroLine-IP-E, VeroTwin-DP-E 89
SBM
Readiness signal
SBM
Mains On signal
4.3.4.0 Ext. off Signal present at the input
“External off”
OPEN
Pump is switched off
SHUT
Pump is enabled for operation
4.3.5.0 BMS protocol type Bus system active Only displayed when BMS is
active
LON
Field bus system
Only displayed when BMS is
active
CAN
Field bus system
Only displayed when BMS is
active
Gateway
Protocol
Only displayed when BMS is
active
4.3.6.0
AUX State of “AUX” terminal
4.4.0.0 Device data Displays device data
4.4.1.0 Pump name Example: IP-E 40/160-4/2
(display in ticker format)
Only the basic pump model
appears on the display; ver-
sion names are not shown.
4.4.2.0
Software version of
user controller
Displays the software version of
the user controller
4.4.3.0 Software version of
motor controller
Display the software version of
the motor controller
5.0.0.0 Service Service menus
No. Designation Type Symbol Values/explanations Display conditions

Wilo VeroTwin-DP-E Series Specifications

General

Brand	Wilo
Model	VeroTwin-DP-E Series
Category	Water Pump
Language	English