Installation and operating instructions WILO Mather and Platt – VT pumps 42
12. Pump Lubrication and Connection Data (Refer Fig. No. 24 & 25, Pg. No. 15 for connection
details)
Oil and GREASE LUBRICATED BEARING CONNECTION DATA
13. Recommended Lubricants
Note: For oil Lubrication:
• ISO Grade 46 oil.
• All above oils are compatible with each other when fresh.
• It is unsafe to mix oil of two or more grades for use in bearings.
• Number 46 is Viscosity at 40 degree centigrade in centistokes.
For Grease Lubrication:
• Only lithium base Grease to be used.
• Numbers mentioned stands for consistency.
• Grease of two different grades should not be used.
14. Decommissioning and recycling
The disposal of all material or debris must be done in order to
protect the environment.
WILO Mather and Platt pumps do not contain any dangerous
substances. The major part of the pump is recyclable. The
disposal and recycling of the pump sets must be done in
accordance with the local in force regulations
The dismounting must be done by qualified personal. Clean and
de contamination must be achieved before any transportation or
recycling.
To Next Page
Loading...
