Windhager BioWIN - Parameter Configuration

30
4. For the Service Technician
Select the required item, „Parameters“, „Start-up“, „Actua-
tor test“ or „Settings“ and confirm by pressing the Choose
button – Fig. 85.
For further settings, see sections 4.6.1 - 4.6.4.
Fig. 85
Parameters
Start-up
Actuator test
Settings
Choose Back
Fig. 86
Parameters
Start-up
Actuator test
Settings
Choose Back
The menu item or sub-menu item is exited by pressing the
Back button or after a delay of 45 seconds – Fig. 86.
4.6.1 Parameters
The following parameters can be selected with the arrow buttons, then confirmed using the Choose button.
– Number of burner starts
– Fuel quantity auger conveyor
– Delivery time ignition phase
– Hysteresis Burner ON
– Maximum value of set temperature
– Set temperature ext. heating requirement
– Type of pellet feed system
– Operating time of suction turbine
– Ash removal profile
– Cleaning interval correction
– Flue gas thermostat or Air intake/ exhaust flap
– Limits for blower speed
– Minimum operating time with buffer