Winegard ConnecT 2.0+ User Manual

STATUS SCREEN MESSAGES:
Connected to WiFi XXXX The Winegard ConnecT 2.0
+
unit is communicating with the source WiFi signal and working. If you
are unable to connect to the internet, the source signal may have a problem.
Scanning The Winegard ConnecT 2.0
+
unit is looking for WiFi signals in range. This can take a few minutes.
Once the unit is able to identify all of the signals, they will be listed and you will be able to choose
one.
Trying to Connect to WiFi XXXX You have selected a source signal and the Winegard ConnecT 2.0
+
unit is attempting to connect to
this source. Once connected, the message should change to “Connect to…”
Logging into WiFi XXXX The source signal is password protected. This message will be displayed after you have entered the
correct password and the two systems work out the security protocols.
Bad Password The source signal is password protected. This message will be displayed after you have entered an
incorrect password and the source system has rejected the connection. Generally this screen will
only be seen if the source signal is distant or weak. Normally, the password will be rejected on the
network password screen.
Not Connected The Winegard ConnecT 2.0
+
system is not connected to a network.
Connecting to WiFi XXXX The Winegard ConnecT 2.0
+
system is communicating to the selected source signal and a
connection is being made. This will generally only take a minute or two.
Troubleshooting
LED DEFINITION (LOCATED UNDER THE SIM CARD/ LED COVER) :
LED OFF System is powered down.
SOLID RED System is booting up.
FAST BLINKING GREEN System is initializing.
FAST BLINKING ORANGE System is up and waiting for an Internet connection.
SOLID GREEN System is connected to the Internet.
ALTERNATING GREEN/ORANGE System is being updated with new software.
OVER THE AIR ANTENNA OPERATION
WINEGARD
®
CONNECT
™
2.0
+
SUPPORT
Running a Channel Scan
Confirm the antenna power button on the wall plate is powered on.
First time users must run a channel scan after installing the antenna to
receive maximum programming.
A new scan will find any new channels that have been added in your area
as well as finding any channels that have changed or moved.
While the steps to perform a channel scan may vary between televisions or
compatible devices, below are some general guidelines to follow. For more
specific instructions, refer to your device user manual for assistance.
General Instructions
1. Using the remote that came with the TV or compatible device, Select
“Menu.”
2. Select “Channel Setup.”
3. Select “Antenna” or “O-Air Mode” or “Auto-Scan.”
4. Select “Channel Search” or “Channel Scan.”
Run a channel scan anytime the antenna is moved or anytime a channel
is lost. Once you have run a channel scan, you are ready to watch TV.
NOTE: If you are not receiving all desired
channels, check out dtv.gov/maps. On this
site, you can enter the address of your current
location and get a listing of likely channels
available in your area.
13

Winegard ConnecT 2.0+ Specifications

General

Brand	Winegard
Model	ConnecT 2.0+
Category	Extender
Language	English