34| P a g e
Repairs Using Tear Aid
1. Tape off an outline of the repair area with
approx 2 inches on either side of leak
2. Lightly scuff surface with sandpaper
3. Draw outline of repair area on Tear Aid.
4. Verify outline of patch
5. Cut out Tear Aid patch
7. Peel off an edge of backing of Tear Aid
8. Place patch on area, slowly peeling off
the back during placement.
9. Apply pressure to Tear Aid with putty knife or
similar firm edge (i.e. credit card or plastic knife).
10. Peel away outline tape, inspect.
To Next Page
Loading...