39| P a g e
9. Apply heat and pressure.
10. Wipe fabric with solvent.
11. Immediately apply outside patch, applying heat and pressure
on one edge. Carefully work heat and pressure towards far edge
avoiding air pockets or bubbles.
12. Allow patches to cure before inflation a minimum of 2 hours
(24 hours is recommended).
13. Upon inflation apply soapy water to ensure quality of patch.
IMPORTANT NOTE REGARDING SEALING EXPOSED
EDGES OF FABRIC:
We recommend utilizing either Clifton one- or two-part adhesive,
or Goop to seal the exposed edges of fabric patches against water
intrusion and air loss though patch edges.
To Next Page
Loading...