Maintenance
Group3
RT-flex58T-E
Winterthur Gas & Diesel Ltd.
1/ 3
Crankshaft: Measuring Crank Deflection 3103−1/A1..................................
Vibration Damper
− Taking a Silicone Fluid Sample 3130−1/A1........................................
− Inspection (GEISLINGER Vibration Damper) 3130−2/A1............................
Axial Damper: Dismantling and Assembling 3140−1/A1................................
Turning Gear: Checking the Toothing 3206−1/A1......................................
Crankcase: Utilization of Working Platform 3301−1/A1................................
Connecting Rod
− Loosening and Tensioning the Connecting Rod Studs 3303−1/A1....................
− Inspection, Removal and Fitting of Bottom End Bearing 3303−2/A1...................
− Inspection, Removal and Fitting of Top End Bearing 3303−3/A1......................
− Removal and Fitting 3303−4/A1..................................................
− Removal of Bearing Cover to Top End Bearing 3303−5/A1..........................
Crosshead
− Checking the Clearances and Fitting the Guide Shoes 3326−1/A1....................
− Removal and Fitting of a Crosshead Pin 3326−2/A1................................
Piston
− Removal and Fitting 3403−1/A1..................................................
− Changing the Compression Shims 3403−2/A1.....................................
− Dismantling and Assembling 3403−3/A1..........................................
− Checking Piston Top Surface 3403−4/A1..........................................
Piston Rings
− Checking Wear of Piston Rings and Ring Grooves
(Piston with four Piston Rings) 3425−1/A1.........................................
− Checking Wear of Piston Rings and Ring Grooves
(Piston with three Piston Rings) 3425−1/A2........................................
Crankshaft
Connectin
Rod and Piston Grou
3
Winterthur Gas & Diesel Ltd. RT−flex58T−E / MM / 2013-08
To Next Page
