English
3
C535
CONTROLS
Reset Button
After replacing a lter,
press the RESET button
for at least 5 seconds.
Fan Speed
Indicator
Indicates the
current fan speed.
Timer Indicator
If timer has been set, the
LED light indicates the set
time of operation.
PlasmaWave
®
Indicator
Indicates whether PlasmaWave
®
is enabled or disabled.
Air Quality
Indicator
Color-coded LED
indicates one of
three levels of air
quality.
Mode Button
Press to cycle through
and set the desired
mode of operation
(Auto, Sleep).
Power Button
Turns the unit on
or off.
Fan Speed Button
Enables Manual operation of the
unit. Press to cycle through and
set the desired fan speed (Low,
Medium, High, Turbo).
PlasmaWave
®
Button
Enables or disables
PlasmaWave
®
.
Light
Sensor
Detects the
amount of
ambient
light in the
environment.
Timer
Button
Press to cycle
through and set
desired length of
operation (1hr,
4hr, 8hr).
Check Filter Indicator
LED light indicates when it is
time to change the lter.
Odor Sensor
When in Auto
Mode, detects the
amount of odor in
the environment
to adjust fan
speeds.
WHERE TO USE
Place indoors away
from direct sun light
direct exposure may cause
product malfunction or failure.
Only place on hard, at surfaces
imsy or slanted surfaces may result
in abnormal noise and vibrations.
Allow 12 ~ 18 in. of space between TVs, radios, and other electronics
electromagnetic interference from certain electronics may cause product malfunction.
Allow at least 4 in. from walls
for maximum air ow.
To Next Page
Loading...
Need help?
General
