Winix C535 - INSTALLING FILTERS; Filter Removal and Preparation; Filter Installation Procedure

English
5
C535
Note
INSTALLING FILTERS
This product comes with all the required lters. The protective
plastic wrap must be removed from the lters before use.
• Operating the unit without removing the plastic wrap may result in
product failure.
• Unplug and make sure the unit is turned off before installing lters.
Remove the front panel by
grasping its upper edge and
gently pulling forward.
Remove the lters from the unit.
They are protected inside a
plastic wrap.
Remove lters from
protective plastic wrap.
Operating the unit without
removing lters from plastic
wrap may cause abnormal noise,
deformation, or re as a result of
overheating.
Install the lters until
they t securely in place.
Filters must be installed
in this order:
3. True HEPA Filter (back)
2. Carbon Filter Sheet (middle)
1. Pre-Filter (front)
Latch
3
True HEPA
Filter
2
Carbon
Filter
1
Pre-Filter
To install the Pre-Filter, insert bottom tabs into the slots on
either side of the lower part of the unit, then rotate upward to
insert the upper tabs into the slots at the top part of the unit
until sides audibly click into place.