Winix C535 - REPLACING FILTERS; Removing Used Filters; Preparing and Inserting New Filters; Resetting the Unit After Filter Change

English
9
C535
소피아 2 영문
소피아 1
NOTICE
Remove the front panel
by grasping its upper
edge and gently pulling
forward.
Press on the Pre-Filter
tabs near the top of the
filter, release and remove.
Pull out the Carbon Filter
and True HEPA Filter.
Carbon
Filter
Insert the True HEPA
Filter rst, then the Odor
Absorbing Carbon Filter.
Insert the Pre-Filter. Put the front panel back on.
▶
True
HEPA
Filter
Latch
▶
Pre-Filter
▶▶
Tabs
Tabs
Pre-Filter
Latch
Remove Used Filters
Turn the unit power off before removing lters.
Prepare New Filters
Remove lters from protective plastic wrap.
Operating the unit without removing
lters from plastic wrap may cause
abnormal noise, deformation, or re as a
result of overheating.
For optimal performance, only Genuine
Winix Replacement lters should be used
with this unit.
Resetting the Unit
After replacing the lters, turn the power
onto the unit and then use a thin object,
such as a paper clip, to press the RESET
switch for 5 seconds.
Insert New Filters
Install the lters until they t securely in place.
REPLACING FILTERS
1
1
2
2
3
3