SECTION 3 –
DRIVING YOUR MOTOR HOME
3-10
NOTE: If power is gradually drained and falls
below the lower limit of 11-volts, the
motors could lose their electronic Set
Limits and will require reprogramming
once normal power has been restored.
Refer to the Solar/Night Shade
manufacturer’s information provided in
your InfoCase.
ELECTRONIC COMPASS AND
OUTSIDE THERMOMETER
Further Information
See the compass manufacturer’s guide in your
InfoCase for detailed operating instructions,
calibration, specifications, and other information.
GPS NAVIGATION SYSTEM
–If Equipped
The GPS navigation system can help you
confidently chart your course through the most
dense concrete jungle or remote country
backroad using global satellite positioning
technology.
Navigational information is displayed on
either the GPS display panel or the rearview
monitor screen using the GPS remote control.
NOTE: Be sure the Input Button on the GPS
Display Panel is set to VIDEO 1.
To operate GPS from the rearview monitor,
press the Input Camera/Aux Switch on the
rearview monitor.
• F/C Button - Press to switch between
Fahrenheit and Celsius temperature degree
scales.
When display is off, press and hold to check
temperature.
• Mode Button - Press to “page through”
functions: Compass > Thermometer >
Calibration.
GPS Display Panel
(Mounted on top of the dash area)
Rearview Monitor
(Located within the dash area)
GPS Control Module
(Located inside driver side
overhead compartment)
GPS Remote
Control
To Next Page
Loading...
Need help?
General
