SECTION 4 –
APPLIANCES AND SYSTEMS
4-10
Further Information
Please read the Energy Management System
Owners Guide in your InfoCase for important
information on how this system operates under
several conditions, whether 20-amp, 30-amp, or
50-amp connections.
WATER HEATER - GAS/
ELECTRIC
-If Equipped
(with Motoraid water heating system)
* NOT AVAILABLE ON COACHES
EQUIPPED WITH HYDRONIC HEATING
SYSTEM
The gas/electric water heater has a dual power
feature. It can operate from propane gas or 120-
volt house current; or it can use both at the same
time for quicker recovery at times when you are
using a lot of hot water.
Read the Water Heater Operation Manual for
complete Safety Warnings, Operating
Instructions and Maintenance Information
before operating the water heater.
Be sure the water heater is filled with water
before starting either electric or propane gas
operation. To fill the water heater, turn the
Water Pump switch on and open a hot water
faucet anywhere in the coach. When water begins
to flow steadily from the faucet, the water heater
is full.
For Propane Gas Operation
Press the Water Heater switch on the Monitor
Panel. The “Pilot Out” light will glow for about
10-15 seconds, then it will go out. The “Heater
On” indicator will remain lit. If the “Pilot Out”
light comes on during gas operation, it means that
the burner has gone into “lockout” mode and
must be restarted. If this happens, turn the Water
Heater switch off for about 5 minutes, then turn it
back on.
For Electric Operation
Turn on the Water Heater electric element
switch. The shoreline must be connected or
generator running for electric operation.
EMS Display Panel
(Located on Monitor Panel)
-Typical View
Gas Water Heater Switch
(Located on monitor panel)
Electric Water Heater Switch
(Located near monitor panel)
To Next Page
Loading...
Need help?
General
