4-7
SECTION 4 –
APPLIANCES AND SYSTEMS
Generator Hourmeter
See Electrical Systems section for generator
hourmeter information.
Water and Holding Tank Levels
Press and Hold the appropriate button to show
approximate tank level on the monitor lights.
The approximate fluid levels are measured by
sets of electronic sensors (detector cells) on the
sides of the tanks. There is generally more fluid
in a tank than indicated on the monitor panel.
For example, if the fluid level is 1-2” below
the FULL sensor, the monitor will show the level
to be only 2/3 even though the tank is nearly full.
If a tank is about 1/4 full, the monitor will
register an empty tank because the fluid level is
below the 1/3 sensor even though there is still
fluid in the tank.
However, when the indicator reads FULL, the
tank is actually full.
For your convenience there is also a tank
monitor panel in the water service center
compartment.
Tank Capacities
See Section 1 - Tank Capacities.
Propane Gas Level
Press and hold the “LP GAS” button to show
approximate propane tank level.
Generator Switch and Hourmeter
-Typical View
-Typical View
Water Tank
Water Level
Sensors
Water Center Tank Level Monitor
-Typical View
To Next Page
Loading...
Need help?
General
