SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
10-6
Operator’s Manual in your InfoCase for
control box fuse replacement information.
If no fuses are blown, go to the next step.
• If the batteries and fuses are okay, there may
be a failure in the hydraulic control system or
electrical system, which requires service.
Retract the room using the following
emergency retract procedures and contact
your dealer for service.
SLIDEOUT EMERGENCY
RETRACTION PROCEDURES
Front Slideout Rooms - Emergency
Crank-In Procedure
(If slideout room will not retract using
control switch)
Step 1: Relieve Hydraulic Line Pressure
• Open the hydraulic pump slideout solenoid
valves to release hydraulic line pressure and
let fluid bypass into the fluid reservoir.
NOTE: The hydraulic pump is located beneath
the entrance steps. To access the pump,
lift up the step cover and remove the
storage bin.
Hydraulic System Control Box
(Located on pump beneath chassis
near LH or RH front tire)
Entry Step Storage
(Lift removable storage bin out to
access hydraulic pump)
To Next Page
Loading...
Need help?
General
