3-15
SECTION 3 –
DRIVING YOUR MOTOR HOME
• Press and release to blink or flash the
headlights.
• Night: If the headlights are already turned on,
pressing the switch will blink them off briefly.
• Day: If the headlights are off, pressing the
switch will flash them on briefly.
NOTE: Truckers often use this signal to indicate
to a passing rig when it is clear to pull
back into the lane ahead of them.
Marker Light Courtesy Flash
• Press and release to blink or flash the marker
(clearance) lights.
• Night: If the marker lights are already turned
on, pressing the switch will blink them off
briefly.
• Day: If the marker lights are off, pressing the
switch will flash them on briefly.
NOTE: Truckers often use this signal as a
greeting or an expression of thanks for
assistance in passing, etc.
Cruise Control Functions
On/Off (Cruise System On/Off)
• Press to turn cruise control system on or off.
• This will also erase previously set speed.
Set (Set Speed/Coast)
• Press to maintain current desired driving
speed. Will not work below 40 mph.
• This button will also perform “Coast” feature.
Press and hold until vehicle slows to desired
speed and release to establish new “set”
speed.
Res (Resume/Accel)
• Press to return to previous “set” speed after
braking or reducing speed.
Cancel
• Press to switch cruise function off without
losing current “set” speed.
Wiper Functions
There are four wiper control buttons:
• Wiper On - HI/LO
•Wiper Off
• Wiper Delay
• Wash/Wipe
WARNING
Do not operate the cruise control on icy or
extremely wet roads, winding roads, in
heavy traffic, or in any other traffic
situation where a constant speed cannot
be maintained.
To Next Page
Loading...
Need help?
General
