3-13
SECTION 3 –
DRIVING YOUR MOTOR HOME
HAZARD WARNING FLASHERS
The hazard warning flashers provide
additional safety when the vehicle must be
stopped on the side of the roadway and presents a
possible hazard to other motorists. When the
flashers are on, it serves as a warning to other
drivers.
NOTE: Move multi-function lever up or down to
cancel.
Further Information
See the chassis manual in your InfoCase for
instructions on activating, operating, and
canceling hazard warning flashers.
SIGNAL LEVER/HEADLIGHT
HI/LO BEAM
The signal lever controls the turn signals and
high/low beam changing.
Move multi-function lever upward for right turn
signal and downward for left turn signal. An
audible chime will alert you when the signals are
flashing.
Pull end of handle toward you to switch
headlight high/low beams.
Further Information
See your chassis manual for further operating
instructions and features.
MAP LIGHT SWITCH
Turn the map light on using the Panel Light
brightness thumbwheel control. Roll it upward
until you feel it click into the map light “On”
position.
The “Cargo” Switch and the “Push” Switch
(for fog lights) are non-functional.
Turn Signals/Hi-Lo Beams
(Typical View - your coach may differ
depending on model)
To Next Page
Loading...
Need help?
General
