SECTION 3 -
DRIVING YOUR MOTOR HOME
3-4
Keys have an identification number, either a
small metal tag or stamped into the key head.
These numbers are recorded on the vehicle’s
component model/serial sheet which is included
in your InfoCase. In case keys are lost or stolen,
your dealer or a locksmith can provide you with
duplicate keys or modify the locks.
REARVIEW MONITOR SYSTEM
–If Equipped
The rearview camera monitor system lets you
see what’s directly behind your coach for
maneuvering assistance and safety.
A microphone built into the rear camera lets
you hear warning sounds or verbal directions
from an assistant.
Basic Operating Instructions
*Sideview Cameras
– If Equipped.
The optional sideview cameras allow you to
see what’s beside you before turning or changing
lanes.
The sideview cameras activate with the
corresponding turn signals and replace the rear
camera view on the monitor until the turn is
completed or the signal lever is canceled
manually.
Further Information
See the rearview monitor manufacturer’s
complete operating information in your
InfoCase.
MIRRORS – POWER ELECTRIC
–If Equipped
Always adjust mirrors for maximum rear
visibility before driving off. Make sure the seat is
adjusted for proper vehicle control and that you
are sitting back squarely into the seat.
Mirror Adjustment Control
The mirror control is located on the driver side
armrest panel or the dash. The ignition key must
be on to adjust the mirrors.
Power - Turn ON to activate
monitor for rear viewing while
driving or parked. Key must be on.
In OFF (Standby) position the
monitor is ‘asleep’ and will ‘wake
up’ when the transmission is
shifted into Reverse.
Camera -
CA1= Rear or Side* cameras
CA2= not used
Day/Night - Press to adjust
contrast and brightness for
nighttime and daytime lighting
conditions. After making
adjustments, button is used to
switch between settings.
Volume, contrast and brightness
are self-explanatory.
To Next Page
Loading...
