10-7
SECTION 10 -
SLIDEOUT ROOMS AND LEVELING
It may be necessary to move the handle
slightly from side to side to fit it onto the shaft.
The crank handle will only move the arm that it
is inserted into. Consequently you will need to
alternate between each crank handle on each side
to move the room in or out. If help is available a
second person cranking on the other handle
simultaneously will greatly speed up the process.
At no point in the cranking process should you let
one side get more than 2 inches (50 mm) ahead of
the other. The most effective way to retract the
room using a single person is to crank one side
ahead of the other, then crank the other side in
(“walk” the room in).
Further Information
See the Slideout Room operating guide
included in your InfoCase for further instructions
and troubleshooting information.
GENERAL SLIDEOUT CARE
• Wipe outer seals occasionally with talc or 303
brand protectant for smooth quiet operation.
• Clean the floors inside before retracting the
room to avoid vinyl flooring scratches or
carpet pile snags.
• See your authorized dealer for regular
maintenance and service of the slideout
mechanism.
CAUTION
Never let one side get more than 2 inches
(50 mm) ahead of the other while
retracting.
To Next Page
Loading...
