3-7
SECTION 3 -
DRIVING YOUR MOTOR HOME
CB RADIO POWER WIRING
Your coach is pre-wired for CB radio power
connection. The wires are located beneath the
dash to the left of the steering wheel.
Look for a pair of wires, yellow (+) and white
(-), with connectors and flag labels, suspended
from the wiring harness.
ENGINE ACCESS – EXTERIOR
Hood Panel
Insert the tamper-resistant hood key into the
hood locks and turn them to the right (clockwise)
to unlock the hood.
Swing the hood panel outward and down. Do
not let panel drop.
To close the hood, lift and swing inward. Turn
key locks to the left (counterclockwise) to lock
hood closed.
With the hood open, the engine oil dipstick,
oil fill, radiator fill, power steering reservoir and
windshield washer reservoir are accessible.
Some chassis also allow access to the engine
air filter element.
ENGINE ACCESS – INTERIOR
Front Engine Cover
• To remove the engine cover, insert the
supplied hex wrench into the hole in the top
center or the front edge of the engine cover.
Turn the hex wrench to the left
(counterclockwise) to unlatch.
NOTE: On some models there may also be
screws to remove at the lower front
corners. See photo.
Radio Power Switch
• Press HOUSE to listen to the radio while
parked without the ignition key on.
• Press ENGINE to listen while driving.
CB Power Wires
(in plastic sheath)
typical view - your coach
may differ slightly
(Typical View)
Insert hex wrench into the hole on the
top center of the engine cover (as
shown) or the front edge of engine
cover to unlatch.
To Next Page
Loading...
