SECTION 6 –
ELECTRICAL
6-6
Generator Basic Operation
(LP Generator)
NOTE: If the GenSet Start or Stop switch is
momentarily pressed, the monitor panel
will automatically try to start or stop the
generator.
Refer to the manufacturer’s user guide
provided in your InfoCase for additional
information.
To Start the Generator
Press and Hold the GenSet Start button until
you hear the Generator running smoothly, then
release.
To Stop the Generator
Press and Hold the GenSet Stop button until
you hear the Generator come to a full stop, then
release.
Generator Hourmeter
The Generator hourmeter registers the total
number of hours that the Generator has been
operated. Press the GenSet Meter button once to
get reading.
Refer to the hourmeter to determine when
periodic maintenance is due and to record
services which have been performed.
Generator Basic Operation
(Diesel Generator)
To Start the Generator
• Press the Display ON/Gen OFF button once to
wake the Generator.
• Once “GEN OFF” appears on the display
screen, press and Hold the Generator Start
button until you hear the Generator running
smoothly, then release.
Do not plug the power cord into the
generator receptacle while the generator
is running. Electrical shock can cause
personal injury.
Power CordGenerator
Receptacle
LP Generator Start/Stop Buttons
(Located on monitor panel)
-Typical View
Generator Hourmeter Button
-Typical View
To Next Page
Loading...
Need help?
General
