SECTION 7 –
PLUMBING
7-12
NOTE: If Waste Pump stalls, check breaker in
the load center. If problem persists,
remove end cap and manually turn pump
shaft (located on the end of the Waste
Pump) with a screwdriver.
Further Information
For further information and operating
cautions, see the Waste Pump operating
instructions included in your InfoCase.
Dumping Holding Tanks
1. Remove sewage drain hose from front driver
side compartment.
2. Remove dust cap from sewage drain outlet
and connect sewage drain hose. Be sure it is
firmly attached.
3. Place the outlet end of sewage drain hose into
disposal opening.
4. Open the Black Waste Tank Drain valve with
a quick pull and make sure there are no sags in
the hose. Move the hose gently about to
dislodge any waste and ensure complete
drainage. Close the Black Waste Tank Drain
valve as soon as tank is empty.
Waste Pump
(Located behind water service center -
accessible through utility compartment)
-Typical View
Sewage Drain Hose
(Located in front driver side compartment)
-Typical View
Sewage Drain Outlet/Dust Cap
(Located in driver side compartment)
-Typical View
Black Waste Tank Drain Valve
(Located in driver side compartment)
-Typical View
To Next Page
Loading...
Need help?
General
