Winterwarm XR - Safety Instructions; Installation Safety; Dust Protection; Temperature Limits

3
INSTRUCTION MANUAL AIR HEATER TYPE XR
1 Introduction
This manual is intended for the gas, electrical and
mechanical installer.
This document gives instructions on how to use and
maintain the air heater. It is most important to follow the
instructions in this document for safe operation of this air
heater.
It is important to read this document before starting the
installation process. Store this document close to the air
heater for quick reference.
1.1 Symbols used in this manual
DANGER! Indicates a dangerous situation that would lead
to death or severe injury.
WARNING! Indicates a potentially dangerous situation
that could lead to death, severe injury or serious product
damage.
CAUTION! Indicates a potentially dangerous situation
that could lead to injury or product damage.
NOTICE Indicates important information that is not
directly related to safety.
1.2 Warranty
NOTICE Using, installing or maintaining this air heater in
any other way than described in this manual may cause
damage that voids the warranty.
NOTICE Failing to follow the safety instructions in this
manual can lead to damage to the air heater or the
installation and void the warranty.
2 Safety instructions
Always follow the safety instructions in this chapter when
installing, using or performing maintenance on this air
heater:
2.1 Installation
CAUTION! This air heater must be installed and
maintained by an authorized, qualified and competent
installer, using calibrated equipment.
NOTICE This air heater must be installed and maintained
in accordance with this manual, national and local building
regulations and local health and safety regulations.
2.1.1 Protection against dust
CAUTION! Do not use the air heater in a very dusty
environment. Dust may accumulate and cause a defect of
the heater. This is also the case for the room thermostat.
2.1.2 Temperature
CAUTION! Do not install the heater in places where the
temperature can rise above 35°C. Higher temperatures
cause the internal components to degrade much faster.
NOTICE Air heaters installed in very cold environments
may form condensate in the flue system. Make sure a
condensate discharge is installed.
2.1.3 Corrosive vapours
WARNING! Do not install the air heater in areas that
contain any corrosive or explosive vapours. Corrosive
vapours (e.g. containing Chlorine) that are sucked into the
air intake will cause corrosion of the heat exchanger and a
leakage of condensate and flue gas. This is also the case
for the room thermostat.