What to do if transmitter power supply is not functioning in Wintriss Indoor Furnishing?
If the transmitter power supply of your Wintriss Indoor Furnishing is not functioning, unplug the transmitter connector at the transmitter. If DS4 turns ON, the transmitter is defective. If DS4 stays OFF, reconnect the transmitter and unplug the transmitter connector at the control. If DS4 turns ON, the transmitter cable is shorted and must be replaced.
What to do if receiver head is not getting power in Wintriss Indoor Furnishing?
If the receiver head or transmitter logic of your Wintriss Indoor Furnishing is not getting power, try the following: 1. Unplug the receiver connector at the receiver. If DS3 turns ON, the receiver is defective. 2. If DS3 stays OFF, reconnect the receiver and unplug the receiver connector at the control. If DS3 turns ON, the receiver cable is shorted and must be replaced. 3. Unplug the transmitter connector at the transmitter. If DS4 turns ON, the transmitter is defective.
General| Brand | Wintriss |
|---|---|
| Model | Shadow VI |
| Category | Indoor Furnishing |
| Language | English |
Warning about using on machines that cannot be stopped mid-stroke.
Critical safety warning regarding incorrect installation, use, or maintenance procedures.
Warns about the need for brake monitors when stopping time is excessive.
Reiterates the importance of correct safety distance calculation and mounting.
Emphasizes ensuring no reach-over, under, or around the curtain into the hazardous area.
Safety warning about preventing operators from being trapped.
Critical warning about mounting the control in a location that doesn't affect operation.
Safety instruction to mount controls outside guarded areas for perimeter applications.
Critical safety warning against use on machines that cannot be stopped mid-stroke.
Warning about ensuring immediate stop signal to prevent continued machine movement.
Safety warning to remove power before aligning or tightening components.
Critical warning about performing safety system tests before operating machinery.
Warning that changes in stopping time necessitate safety distance recalculation and adjustment.
Critical warning against unauthorized repairs, emphasizing qualified personnel.
Safety precaution to disconnect power before checking or replacing relays.
Critical warning about replacing the entire control board for failed relays.
Safety precaution to disconnect power before making wiring connections.
To Next Page