Wirepath Surveillance WPS-100-DVR - Page 67

67
WPS-100-DVR-4CH Installation and Users Manual
7KHIROORZLQJLVDEULHIGHVFULSWLRQIRUHDFKLWHPLQWKLVPHQXDQGLWVVSHFLÀFRSHUDWLRQV
 &$0(5$
  6HOHFWWKHFDPHUDWRGHÀQHPRWLRQWULJJHUHGHYHQWV
 '85$7,21
Set the length of time the buzzer and the corresponding Alarm Out relay will remain triggered once
motion is detected for this camera. The buzzer and Alarm Out relay will reset immediately once motion
is no longer detected.
 &$0(5$72*2
This feature is not available on WPS-100-DVR-4CH.
 *27235(6(7
This feature is not available on WPS-100-DVR-4CH.
 35(5(&25'
  'HÀQHKRZPXFKWLPHWKH'95ZLOOUHFRUGEHIRUHPRWLRQLVGHWHFWHG7KH3UH5HFRUG)36VHWLQSection
9.3.5 determines the frame rate of this recording.
  1RWH$FWXDOSUHUHFRUGWLPHPD\EHVKRUWHUWKDQWKHYDOXHVHWLIWKHWRWDOVL]HRIWKHSUHUHFRUGYLGHR
exceeds the pre-record video buffer.
 32675(&25'
  'HÀQHKRZPXFKWLPHWKH'95ZLOOUHFRUGDIWHUPRWLRQLVGHWHFWHG7KH3RVW5HFRUG)36VHWLQSection
9.3.5 determines the frame rate of this recording.
 $/$50287
This feature is not available on WPS-100-DVR-4CH.
 %8==(5
  %\GHIDXOWWKHLQWHUQDOEX]]HULVGLVDEOHGWRVRXQGZKHQPRWLRQIRUWKLVFDPHUDLVGHWHFWHG
 /2*
  %\GHIDXOWWKH'95ZLOOORJWRWKH(YHQW/RJZKHQPRWLRQLVGHWHFWHG
 (0$,/
  6HQGDQ(PDLOPHVVDJHWRSUHGHÀQHG(PDLODGGUHVVLQWKHHYHQWPRWLRQGHWHFWHGIRUWKLVFDPHUD
See Section 9.3.11 for more information on E-mail.
)73
This feature is not available on WPS-100-DVR-4CH.
6&5((10(66$*(
  %\GHIDXOWWKH'95ZLOOGLVSOD\DPRWLRQGHWHFWLRQPHVVDJHLQWKH6\VWHP6WDWXV%DUYLVLEOHIURPWKH9*$
or BNC main monitor output only) when motion is detected for this camera.