WiXHC MK3-V - Ports and Pins Configuration; Motor Output Configuration; Input Signal Configuration

6.2 Ports and Pins
6.2.1 Motor outputs
Open Mach3 Software，select "Config">>“Ports and Pins”
>>“Motor tuning”
1. Tick to make the axis output
2. Motor direction selection
3. Tick to make the axis output
Enable:
Dir Lowactive:
Step Lowactive:
6.2.2 Input signals
Open Mach3 software，select "Config">>“Ports and Pins”
>>“Input signals ”
Basic parameters
29