45 VoIPNetworkServicesGmbH,Justus‐von‐Liebig‐Str.26,31535Neustadt
Field Name Description
Provision Enable If or not enable provision.
Resync on Reset If or not enable resync after DIV378 restart
Resync Random Delay (sec) Set the maximum delay for request the synchronization file,
default is 40.
Resync Periodic (sec) If the last resync was failure, WB100A will retry resync after
the “Resync Error Retry Delay ” time, default is 3600s.
Resync Error Retry Delay (rec) Set the periodic time for resync, default is 3600s.
Forced Resync Delay (sec) If it’s time to resync, but WB100A is busy now, in this case,
WB100A will wait for a period time, the longest is “Forced
Resync Delay”, default is 14400s, when the time over,
WB100A will forced to resync.
Resync After Upgrade If or not enable firmware upgrade after resync, by default it
is enabled.
Resync From SIP If or not enable resync from SIP.
Option 66 It is used for In-house provision mode only. When use
TFTP with option 66 to realize provisioning, user must input
right configuration file name in IP542N's webpage. When
disable Option 66, this parameter has no effect.
Config File Name It is used for In-house provision mode only. When use
TFTP with option 66 to realize provisioning, user must input
right configuration file name in IP542N's webpage. When
disable Option 66, this parameter has no effect.
Profile Rule URL of profile provision file
Note that the specified file path is relative to the TFTP
server’s virtual root directory.
To Next Page
Loading...